What reasons lead to material accumulation phenomenon of vibrating screen?

Some customers said material accumulation phenomenon occurred in the use process of vibrating screen, according to many years of analysis experience, the reasons can be summed up in four aspects:
1.There is a problem of vibrating screen mesh selection, too small mesh will cause a low rate of material passing through the mesh.
2. Check whether the ground level of the vibrating screen is flat or not, besides,high material inlet will affect the material running track, resulting in material tilting to one side.

 

3.Check whether the screen mesh and outlet are horizontal or higher than outlet or not, under normal circumstances, it should be horizontal or 6mm higher, the design is not the same according to different material discharging outlet.
4.There is a problem on the vibration motor angle adjustment, improper angle adjustment of vibration motor will cause material accumulation, if the angle is small,the material will spread outward quickly on the sieve surface,while if the angle is large, the spreading speed will be slow. If you have strict requirements of screening accuracy, the angle can not be too small so as not to affect the screening precision. In general, the vibration motor angle of the vibrating screen is 45 degrees when leaves the factory.
Users can also change the vibration motor angle to 100 degrees according to the the special requirements of the material ,and then material will be concentrated to the central screen mesh.